Beiträge von dpsuk999

The cause of the clicking is low voltage, particularly if the electricity post is far from the distribution point and many people are using it. When this happens switch to gas 👍

Linkage will be my guess if the mobile home has not been used in a while, or the turbo has not been under stress when driven 👍

You must reset shunt again 👍

When you reset the shunt for the new values of the battery bank there is a tick box REVERSED, this must be ticked when the load is installed to the left of the shunt 👍

My TEC29 is petrol and I have a remote solenoid valve which I close whilst the generator is running, and it keeps running until all the fuel has been used in the carburetor to eliminate gumming up which has worked for me for many years 👍 no starting problems or rough running 👍👍

Zitat von Teeyop

The gray plastic part on the left in the awning box causes a gap when the awning is closed, what is that for? I took it out...

The grey part is used when you install the Thule safari room.

Thanks, I've emailed service@morelo.eu but haven't received a response in the past so not hopeful in this case.

Hallo zusammen

Ich habe 4 dieser Lautsprecher in meinem Morelo und möchte wissen, wer diese herstellt, da ich einen kaputten ersetzen muss.

Danke im Voraus

David

I use this:

I too have had the same error message and was the turbo linkage. This is the problem and cleaning/greasing regular will prevent any problems in the future

Hello, this is the spray I use to prevent EDC message. The turbo linkage sticks when not used regularly. I’ve also attached a picture of the turbo linkage and the problem. Sorry it’s in English

David

Check your pump settings, if it's on "cont" instead of

"therm" this will effect the water temperature according to ALDE website.

On "therm" the boiler stays hot and controls the heating temperature by cycling the pump on and

off, on "Cont" the pump stays on continuously and

controls the boiler temperature to control the heating so when the van warms up the boiler cools down.

Regards David

498 for me too

My solution to only having an emergency lever inside the motorhome was to install a remote switch on the passenger window. In the event of a problem with my door I can remotely open the window, climb into the motorhome and then operate the emergency lever 👍

David

I had the similar problem with Dyson Hairdryer, would work using house batteries (600ah lithium) but would not work on shore power. Interim solution was to install a Wi-fi shore power switch so I could turn shore power off without leaving motorhome then wife could dry hair 👍

Now Dyson works perfectly and the ONLY thing I have done was to unplug the main control panel completely (3 plugs) and leave for 1 minute. Please try this 👍

Regards David

Hi, have you tried giving the sensor a good spray of penetrating oil? Or a tip used by many in the motor trade is to apply brake fluid to near the rubber o ring which helps degrade it and it may release easier?

David.

Hello, if you have the Mastervolt system it’s very easy control charging of batteries. I have mine set to only charge when ‘battery pre low’ is reached (20% SOC) and then to stop charging when ‘battery >80%’

David

fantastic, the work on my system, thank you

I will try, thank you

1991 did not work, please more ideas?